CAE and simulation workflow automation
Simulation workflows often contain significant repetitive work around geometry preparation, meshing, solver configuration and results processing. Retsof develops software that automates these steps while preserving the engineering decisions that matter.
RS / 005 / 01
CAD + analysis assumptions
RS / 005 / 02
Preparation / mesh / solve
RS / 005 / 03
Reviewed results + provenance
Automating simulation preparation
Preparation automation is useful when analysts repeat the same checks and transformations across related models. A workflow should establish the geometry revision, units and analysis purpose before changing the model. Missing material data or unclear boundary conditions should stop the process rather than be replaced by convenient defaults. Simcenter and Abaqus environments expose different automation interfaces and model concepts. We design around the actual analysis workflow, including where engineering approval is required.
Geometry preparation
Small features can increase meshing effort without affecting the response of interest, but removing them is an engineering decision. A preparation tool can apply agreed defeaturing rules and identify exceptions. CAD-to-CAE automation should preserve a relationship to the source geometry and record the transformations made. Named selections or geometric criteria are more robust than relying on transient face numbering. The goal is a repeatable analysis model, not simply a model with fewer faces.
Meshing automation
Mesh generation can be parameterised around element type, local refinement and quality requirements. Automation should evaluate mesh quality after generation and report regions that fail agreed criteria. A mesh suitable for one analysis may be inadequate for another. Convergence assessment, contact treatment and features that drive local response therefore need analyst input. We separate reproducible mesh-generation settings from engineering acceptance so a batch workflow does not silently approve unsuitable models.
Analysis setup
Materials, loads, constraints and interactions must be associated with the intended geometry and units. Setup tools can apply templates and check that required entities exist. They should also recognise when a model falls outside the assumptions of the template. Solver input generation needs controlled naming, configuration and version compatibility. An apparently complete input deck is not proof that the engineering problem has been represented correctly.
Solver workflow automation
Execution tools can organise runs, prepare solver inputs and capture completion state. File creation, job submission and result availability are separate events that need separate checks. Resource limits, licence availability and retry behaviour should be considered explicitly. Automated workflows should distinguish a failed solver job from an incomplete engineering model. Keeping the input configuration and software version alongside the result makes repeatability possible.
Results extraction and reporting
Post-processing can extract defined quantities, compare load cases and create consistent reports. The extraction must establish what a reported maximum actually represents: a component, coordinate system, region or step. Automated reports should include input provenance and the assumptions that constrain interpretation. They can reduce routine formatting, but unusual results still need engineering review. Structured output is also useful for PLM integration when results must be related to a product revision.
CAD-to-CAE automation and standardisation
A joined workflow connects design geometry, preparation rules, analysis setup and reviewed output. It should state where data is copied, transformed or approved. Standardisation is valuable when it makes modelling assumptions visible across a team, not when it forces every analysis into one template. We define interfaces and validation gates so engineers can improve a stage without losing traceability across the whole process.
CAE & Simulation Automation: practical questions
Which simulation processes can be automated?
Repeatable geometry preparation, mesh generation, setup, solver execution and results extraction can be automated where the platform interfaces and analysis rules support them.
Can CAD geometry be prepared automatically for simulation?
Yes, using validated simplification and identification rules. Engineers must define what can be removed or changed for the intended analysis.
Can meshing workflows be automated?
Mesh generation and quality checks can be automated. Mesh suitability and convergence still require analysis-specific engineering criteria.
Can automation generate solver inputs?
Yes. Materials, loads, constraints and units must be validated before generating and submitting input files.
Can results processing and reporting be automated?
Defined outputs and report structures are good candidates. Interpretation of unexpected behaviour should remain with an analyst.
